PancBike

50kg Body Load Cell Weighing Sensor Resistance Strain Half-bridge Total Weight Scales Sensors Pressure Measurement for arduino

Share
Share
Availability: In Stock
रू 800
Promotions

>




click to check available discount coupons

Estimate Shipping

Select Province

  • Provinces No 1
  • Provinces No 2
  • Provinces No 3
  • Provinces No 4
  • Provinces No 5
  • Provinces No 6
  • Provinces No 7

      Warranty

      No Warranty
      Sold By PancBike

      View other products by this seller

      Shipping from: Kathmandu

      Fullfilled by Sastodeal.com

      • Size 34mm
      • internal 1000 Ohm half bridge strain gauge load cell
      • range 50kg half bridge structure
      • use a sensor with external resistor full bridge
      • range can be increased by adding scales
      • Brand new
      • Size: approx.34*34mm
      • Widely used in weight scales.
      • When measuring, the correct force is applied to the outer side of the strain E-shaped beam portion of the sensor (i.e., a strain gauge affixed to the middle, with a beam of white plastic cover arm) and the outside edges to form a shear force in the opposite direction, i.e., in the middle of strain beam bending necessary changes can occur under stress, strain beam side by another force can not have a barrier.
      • Three methods to use:
      • Using a sensor with external resistors full bridge measurement range of a sensor range: 50kg. Higher requirements for external resistor.
      • The use of only two full-bridge sensors measuring range is the range of the two sensors and: 50kg*2 = 100kg.
      • The use of four full-bridge sensors measuring range is the range of four sensors and: 50kg*4 = 200kg.

      Highlights

      Write Your Own Review
      You're reviewing:50kg Body Load Cell Weighing Sensor Resistance Strain Half-bridge Total Weight Scales Sensors Pressure Measurement for arduino
      Your Rating